How to fix error code E003-0000 CANON IR 2420/2318. Here in this post I explain Canon Ir2318, ir2420 series copier How to fix error code E000-0000, e002-0000 and E003-0000 which should solve your problem. We are sharing a few methods to fix the error, so check them one by one until it gets solved.
Canon IR 2420, 2318 reset error code E003-0000
Here in this post, I explain Canon Ir2318, ir2420 series copier How to fix error code E000-0000, e002-0000, and E003-0000 which should solve your problem. We are sharing a few methods to fix the error, so check them one by one until it gets solved.
The maintenance sign means that the copier needs to be well serviced and checked if something is to be replaced. Consumables such as Toner, Drum, Blade, Fuser rollers, Pickup roller, and Developer are changed at such times. And also check the changing consumables are original or not. Always use spares having good quality. If you are sure that you have replaced the correct part or nothing is to be replaced, after ensuring these things, you can proceed to clear the sign. Always call experienced technicians for service.
The maintenance sign means that the copier needs to be well serviced and checked if something is to be replaced. Consumables such as Toner, Drum, Blade, Fuser rollers, Pickup roller, and Developer are changed at such times. And also check the changing consumables are original or not. Always use spares having good quality. If you are sure that you have replaced the correct part or nothing is to be replaced, after ensuring these things, you can proceed to clear the sign. Always call experienced technicians for service.
Meaning of the error code
The E000-0000 error code is for the fixing assembly not getting to the correct temperature in a specified time. The reading of the main thermistor is less than 30 deg C continuously for 200 msec or more 1sec after the start of power supply. While start-up control is underway, the reading of the main thermistor is less than 70 deg C continuously for 200 msec or more 2 sec after 2 sec the start of power supply. While start-up control is underway, the reading of the main thermistor is less than 70 deg C continuously for 200 msec or more 2 sec after 6 sec the start of power supply. The start-up control does not end 30 sec after the start of the power supply. The Fuser code needs to be reset in the service mode. It is easy to do.
How to fix the error code:
Do not worry if you get this error, you can fix it in some of the simplest processes. Follow the steps below:
- Press additional function (*) button on the control panel.
- Press the 2 and 8 buttons at the same time once.
- Then press the # button on the keypad.
- The service mode screen will open. Then Scroll down to clear data then press "OK".
- Scroll down to "All data".
- Then press "OK" and press YES.
- And switch off the machine then on again.
In this way, you will have cleared then ram then does paper size registration by going to CST intermediate screen put different sizes of paper in the ADF one at a time keep pressing ok for each size selected.
Even if the above fixes are shown in error code. Then check these all things.
Some possible causes.
- Check the connector of the fixing film unit.
- Check the fuser film.
- Replace the fixing film unit.
- Replace the DC controller PCB.
After you replace the part, then you have to reset the machine in service mode COPIER
I hope this was helpful, don’t forget to share it via any of the share buttons on this page are highly welcomed as well.
I have a paper jam error on my canon ir2830
ReplyDeleteWhat could be the cause of this.. because there is no paper inside in it..