How to resolve error code F2 with sharp AR-5620

Sharp AR-5618, AR-5620 error code F2

How to resolve error code F2 with sharp AR-5620

Here in this article I explain how to solve your Sharp AR-5620, AR-5618 error code F2. This should solve your problem. We are sharing a few methods to fix the F2 error in Sharp AR-5618, AR-5620,AR-5623, AR-5520 and AR-5516 so check them one by one until it gets solved.

How fix the F2 error code.

F2 code means problem with toner cartridge error. Sometimes F2 is caused by lose or broken harness in scanning section, in this case it sometimes display an E7 code. When f2 flashes on display just press start key you will receive a sub code. If sub code is F2-02 this is toner supply problem. If F2-04 toner chip is damaged, replace the chip. If F2-40 developer is damaged, change the developer.



·        Clean toner cartridge CRUM chip contacts and check if cartridge destination is proper for your area.
·        This code you may have to clean out the developing unit and start with fresh developer. Make sure the developer unit is not leaking from one of the bearings. You may need a tech for this one.
·        Replace the toner cartridge.
·        Change the developer.

If you find your parts, then replace the parts and error still remains, after automatically reset the error code. If the error is still showing even after above solutions, then you have no choice other than calling Sharp service technician.


I hope this was helpful, don’t forget to share it via any of the share buttons on this page are highly welcomed as well.

0 comments: