How to fix canon ir2016 error code e808

Canon ir2016, ir2018, ir2022, ir2020, ir2318 and ir 2420 copier system error e808 solution. Meaning of the E808 Error Code. E808 is a Zero Cross error. This might have occurred while replacing the fixing assembly or performing a troubleshooting attempt on the machine. Maybe the problem power supplies or bad wall voltage cause this code, doesn’t get enough power to heat up. Also if you want to prevent power issues you can place power stabilizer before copiers power supply.

Canon ir2420, ir2016 system error e808 solution

How to fix canon ir2016 error code e808

Are you getting the status as E808 signal on your display of Canon ir2016, ir2018, ir2022, ir2020, ir2318 and iR 2420 copier?. These instructions describe a solution for error code E808 for a Canon ImageRunner copier machine. This should solve your problems. This introduction will help you to troubleshoot some common error messages related to Error Code E0007, E001, and E002 that you may receive.

The maintenance sign means that the copier needs to be well serviced and checked if something is to be replaced. Consumables such as Toner, Drum, Blade, Fuser rollers, Pickup roller, and Developer are changed at such times. And also check the changing consumables are original or not. Always use spares having good quality. If you are sure that you have replaced the correct part or nothing is to be replaced, after ensuring these things, you can proceed to clear the sign. Always call experienced technicians for service.

Meaning of the E808 Error Code:

E808 is a Zero Cross error. This might have occurred while replacing the fixing assembly or performing a troubleshooting attempt on the machine. Maybe the problem power supplies or bad wall voltage cause this code, doesn’t get enough power to heat up. Also if you want to prevent power issues you can place a power stabilizer before the copiers power supply.

Some possible causes of the E808 error.

• Check the fixing roller may be some adhesive materials left on the roller and cause the fixing roller not to rotate smoothly. Or some fixing drive gears broke during printing on heavy media.
• Replace the presser roller bush.
• Check the connector of the fixing film unit.
• Replace the fixing drive motor.
• Replace the DC controller PCB.
• Replace the power supply PCB. 

After you replace the part, then you have to reset the machine in service mode.

I hope this was helpful, don’t forget to share it via any of the share buttons on this page is highly welcomed as well.