How do you reset a C6000 error on a Kyocera KM-2530/km-3530/km-4035

Kyocera KM-2530, KM-4030, KM-3530 error code C6000

Here in this article I explain how to solve your Kyocera Mita km 2530 error code c6000. This article will help you to troubleshoot some common error messages related to Error Code C602O, C6050 that you may receive any of the Kyocera Mita-2530, KM-2540, KM-2550, KM-2560, KM-3035, KM-3040, KM-3050, KM-3060, KM-3530, KM-4030, KM-4035 and KM-4050 models.

Meaning of the C6000 Error Code

Kyocera error code C6000 is displayed when your machine fails to reach the correct temperature at a specific time. Fixing unit thermistor 1 detected less than 70C for 10 second during warm-up and ready in. the temperature at the fuser unit thermistor 1 does not rise by 1C/1.8F continuously for 5 s. Fuser unit thermistor 2 detected less than 40C for 10 s during warm-up and ready in. the temperature at the fuser unit thermistor 2 does not rise by 1C/1.8F continuously for 5 s. In some cases, you can solve the error code C6000 by resetting it or when it is a false error, can’t be reset it and may also require new parts.



How to reset the fixing error

To reset this error, do the following.
1.   Press the number key in 10871087 the display should blink.
2.   The display change to Maintenance mode.
3.   Press the 163 and press the start key, the screen for executing is displayed.
4.   Select the EXECUTE and press ENTER
5.   Turn the copier OFF, wait 20 seconds and power up the machine. The fixing problem data is initialized.




It is an error on your heater unit. It sometimes comes with power fluctuation. If you do not know about copiers and their settings then i advice you to rather get a Kyocera technician to do it for you.



I hope this was helpful, don’t forget to share it via any of the share buttons on this page are highly welcomed as well.

0 comments: