How to reset error c3851 in Konica Minolta bizhub 215

How to reset error c3851 in Konica Minolta bizhub 215. Are you getting the status to service call c3451, c3452, c3751, c3752, c3851, c3852 on your Konica Minolta bizhub 164, 195 and 215 copiers? This trouble code c3851 means abnormally low fusing temperature. The machine does not reach the right temperature within a certain amount of time. The reset is easy to set up and will usually eliminate the error.

Konica Minolta bizhub 215 trouble service call c3451

How to reset error c3851 in Konica Minolta bizhub 215

Are you getting the status to service call c3851 on your Konica Minolta bizhub 164, 195 and 215 copiers? The following instructions describe how to reset the trouble code c3451, c3452, c3751, c3752, c3851, and c3852 for a Konica Minolta bizhub copier machine. We are sharing a few methods to fix the error, so check them one by one until it gets solved.

The maintenance sign means the copier should be well serviced and check if something needs to be replaced. Consumables such as drum, blade, fuser rollers, and developer are changed at such times. If you are sure that you have replaced the correct part or nothing is to be replaced, then you can proceed to clear the sign.

Meaning of the service calls c3851:

This trouble code c3851 means abnormally low fusing temperature. The machine does not reach the right temperature within a certain amount of time. The reset is easy to set up and will usually eliminate the error.

Fix the service calls c3851:

To clear the count, use of the Service Mode:

1. Press the Utility button
2. Press the Stop → 0 → 0 → Stop → 0 → 1 (You are now in Service Mode).
3. Then press down arrow button and find “Clear Data” then press ok.
4. Then press down the arrow button and find Total Clear then press the ok.
5. Then YES or NO shows on the display select “YES” and press ok then wait for little mint.

Some possible causes:

• Check the fusing unit for proper installation.
• Check the correct connection to Fixing, MFPB, and DCPU.
• Change the fusing unit.
• Change MFPB.
• Change DCPU.

After you replace the part, you have to reset the machine in serves mode. If the error is still showing even after the above solutions, then you have no choice other than calling the Konica Minolta technician.

I hope this was helpful, don’t forget to share it via any of the share buttons on this page are highly welcomed as well.