Xerox docucolor 250 fault code 010-320 solutions

Xerox docucolor 250 fault code 010-320 solutions. Do you get the signal to fault code 010-320 on your Xerox DocuColor 240, dc242, dc250, dc252, and dc260 copier? The following instructions describe how to reset fuser error for a Xerox docucolor copier machine. You'll save a lot of money by just waiting till the units fail before replacing them. They'll last longer than the reset counters.

Xerox dc250 error code 010-320

Xerox docucolor 250 fault code 010-320 solutions

Do you get the signal to fault code 010-320 on your Xerox DocuColor 240, dc242, dc250, dc252, and dc260 copier? The following instructions describe how to reset fuser error for a Xerox docucolor copier machine. You'll save a lot of money by just waiting for the units to fail before replacing them. They'll last longer than the reset counters.

Meaning of fault code 010-320:

Xerox docucolor 240 error code 010-320 it’s a fuser overheat code. If this happens the first time you need to reset. If this doesn’t work, you may have a bad fuser assembly. Replace the fuser unit or mainboard needs to be replaced.

Fix the fault code 010-320:

1. Press and hold 0 for more than 5 seconds then press start batten.
2. The entry number screen will appear, enter “6789” and press Confirm.
3. Press the “Log In/Out” button on the UI.
4. The System Settings screen appears. Tach the “System Settings”.
5. Tech the “Common Settings”.
6. Tech the “Maintenance/Diagnostics’.
7. Select “NVM Read / Write”.
8. Entry number screen will appear, chain Link “762-315” and tech the “Confirm/change”.
9. You can see the current value 2 or 3, 4 and you need to change this value. Enter “0” and select “save” and tech the “Confirm/change”
10. Then press “Close” the right side top of the touch screen, and "power OFF" and wait until 15 minutes, then “ON” the machine, now your fuser Counter replaces signal is solved.

I hope this was helpful, don’t forget to share it via any of the share buttons on this page are highly welcomed as well.