Are you getting the error code ‘C4000’ on your Kyocera Taskalfa 1801, Taskalfa 205c, Taskalfa 2201, Taskalfa 2552ci copier? The error code C4000 stands for the Polygon motor synchronization problem. The polygon motor is situated inside the laser unit.
Kyocera Taskalfa 1801, Taskalfa 205c error code C4000 Solution
Are you getting the error code ‘C4000’ on your Kyocera Taskalfa 1801, Taskalfa 205c, Taskalfa 2201, Taskalfa 2552ci copier? This article describes the solution for the error code C4000 on a Kyocera Taskalfa 180, 181, 205c, 2202, 2552ci copier machine. This will definitely help you to solve your problem. So, check it out one by one until it gets solved.
The maintenance sign means that the copier needs to be well serviced and checked if something is to be replaced. Consumables such as drum, blade, fuser rollers, and Developer are changed at such times. If you are sure that you have replaced the correct part or nothing is to be replaced, then you can proceed to clear the sign.
Meaning of Error code C4000
The error code C4000 stands for the Polygon motor synchronization problem. The polygon motor is situated inside the laser unit. This error code will display when the polygon motor doesn’t reach the stable speed within 20 seconds of the ‘START’ signal turning ON.
Method to fix error code C4000
Method to fix error code C4000
- If it is due to poor contact in the connector terminals, then clean the connector terminals first. Also, check the connection and continuity in the connector terminal. Replace the connector cable if it is necessary.
- If it is due to defective polygon motor then replace the laser unit or polygon motor.
- Replace engine PWB if it is defective.
Causes
- Poor contact at the connector terminals of the polygon motor.
- This may be due to a defective laser unit.
- Check the engine PWB.
I hope this was helpful, don’t forget to share it via any of the share buttons on this page are highly welcomed as well.
COMMENTS