Sharp MX-3110N Call for service Code L4-11 solution

Call for service Code L4-11 solution for a Sharp MX-3100n, MX-2610N, MX-3110N, MX-3610N, mx2600, MX41OON, MX5000N, MX2301, MX2310, MX2314, MX2614 series Copier. this problem is with the Shift motor or shifter home position sensor. Shift motor is situated after fixing unit, this code is not part of a finisher.

How to remove Call for service Code L4-11

These instructions describe Call for service Code L4-11 solution for a Sharp MX-3100n, MX-2610N, MX-3110N, MX-3610N, mx2600, MX41OON, MX5000N, MX2301, MX2310, MX2314, MX2614 Series Copier. We are sharing a few methods to fix the error, so check them one by one until it gets solved.

The maintenance sign means that the copier needs to be well serviced and checked if something is to be replaced. Consumables such as Toner, Drum, Blade, Fuser rollers, Pickup roller, and Developer are changed at such times. And also check the changing consumables are original or not. Always use spares having good quality. If you are sure that you have replaced the correct part or nothing is to be replaced, after ensuring these things, you can proceed to clear the sign. Always call experienced technicians for service.

Meaning of Call for service code L4-11

This error code means Call for service code L4-11 is a problem with the Shift motor or shifter home position sensor. Shift motor is situated after fixing unit, this code is not part of a finisher.

Fix the Call for service code: L4-11

This is a shift motor trouble, sometimes you can solve this by doing reset procedure.

1. Enter the key “#, *, c, *”
2. Now you are in service mode. Type in number “14” and press "start".
3. Then press "Execute" then press "Yes or Start" button.
4. Then press the "CA" button on control panel. The machine will restart and it will work properly.

If that does not work, you need to check these all

Some possible causes

• Check the operation of the shift motor
• Clean the shifter home position sensor.
• Check the harness and the connector between the PCU, PWB and the shift motor.
• Connect the finisher properly because the copier also shows this error code when the finisher is not properly connected.

I hope this was helpful, don’t forget to share it via any of the share buttons on this page are highly welcomed as well.