solutions for the error code 5B00 in the Canon g2000, g3000, g2002, and g2010 printer. You can solve this error code by using the following methods...
This article describes the causes and solutions for the error code 5B00 in the Canon g2000, g3000, g2002, and g2010 printer. You can solve this error code by using the following methods. You need the Canon service tool V4905 or V5302 for solving this error. I hope this article will be able to solve your problem.
how to reset support code 5b00 canon g2000 |
Fix support code 5b00 canon printer
The error code 5B00 in Canon G2010 series printer stands for waste ink counter overflow. This is a common error that occurs in every printer. The printer begins to blink orange and green light alternatively for 7 to 8 times when you try to print or scan. If you try to print anything the error will appear. This error may due to continuous installation of ink system. You can solve this error by resetting it.
how to reset support code 5b00 canon g2000
First of all, check your ink levels. Your cartridges should be half-filled to reset this error. If your ink is empty, refill it and continue the process. You can reset this error by using Canon service tools. You can use the service tools V5302 and V4905.
Follow the steps below to reset the 5b00 error code.
- First of all, you have to enter into the service mode to reset this error code. For that, switch off the printer, Don't unplug it. Don't forget to put the paper on the tray. Press and hold the power button. Now the green light will blink. Hold the power button and press and release the ‘stop' button for 5 times. Then release the power button. wait till the green light is stable. Now your printer is in service mode.
- After entering into service mode open your software (service tool) on the PC by double-clicking on it. You have to connect your printer with a USB. You can see some options on your computer when your printer is connected. Then click on the 'clear ink counter' and set it and also set the 'Ink aborter counter'. Then click on the Finish option. Now turn off and turn ON your printer. The error should be gone. Take a test print and ensure it.
If you can't enter into service mode, you have to replace the EEPROM Chip on the Mainboard for solving this error code. If you are using canon service tool like V3400, V4200, etc., or due to any other reasons you can't enter into service mode. So you must replace the EEPROM Chip.
COMMENTS