Error code SC672-00 on the Ricoh MPC4504, MPC3503, MPC3004, MPC3003, MPC6004 typically indicates a problem related to the hard disk drive (HDD).

How to Fix Error Code SC672-00 on Ricoh MPC4504

If you're encountering error code SC672-00 on your Ricoh MPC4504, mpc3003, mpc3004, mpc4503, mpc6004, amd mov5503 printer, then don't worry. Here we are discussing about how to Fix Error Code SC672-00 on Ricoh MPC4504, mpc3003, mpc3004, mpc4503, mpc6004, amd mov5503. This guide will help you diagnose and fix this issue step-by-step.

What is Error Code SC672-00 on Ricoh MPC4504?

Error code SC672-00 on the Ricoh MPC4504, mpc3003, mpc3004, mpc4503, mpc6004, amd mov5503 typically indicates a problem related to the hard disk drive (HDD). This error code signifies a controller start-up issue, meaning there is a communication error between the operation panel or display panel and the controller after the machine is powered on. Several factors could cause this error.

Possible Causes:

1. Improper communication of display cable to the display panel.
2. Loose or damaged operation panel connector
3. Poor connection of the controller board
4. Defective HDD

Solutions for Error Code SC672-00 on Ricoh MPC4504:

1. Check the Controller board and ensure that it is properly connected. Replace it if needed. 
2. Inspect the IPU board: verify that it is properly installed or not, and check the harness, display cable, etc.
3. Examine the controller LED. And make sure that the lights on the controller board, BCU boards are continuously blinking.
4. Check the operation panel connectors and ensure they are properly connected.
5. Clean the RAM and flat cable
6. Examine the HDD and replace it if necessary.

Don’t forget to share your experience in the comments section and let us know which method resolved your issue. Your feedback is valuable to us.