HOW TO CLEAR ERROR: E00027 FOR Canon imageRunner advance C5045

error E00027 on your Canon ImageRunner advance copier? These instructions describe solution for error code E00027 sub code 100, 200, 300, 400 for a Canon ImageRunner advance copier machine.

 Canon ImageRunner Error Code E00027

HOW TO CLEAR ERROR: E00027 FOR Canon imageRunner advance C5045

Are you getting the error E00027 on your Canon ImageRunner advance copier? These instructions describe a solution for error code E00027 subcode 100, 200, 300, 400 for a Canon ImageRunner advance copier machine. This should solve your problems. This introduction will help you to troubleshoot some common error messages related to Canon imageRunner Advance C5030, C5035, C5040, C5045, C5052, series. If that is the case consider the following.

The maintenance sign means that the copier needs to be well serviced and checked if something is to be replaced. Consumables such as drum, blade, fuser rollers, and developer are changed at such times. If you are sure that you have replaced the correct part or nothing is to be replaced, then you can proceed to clear the sign.

Meaning of the Error Code:

E00027 error Code refers to the developer unit related part. The developer unit is not rotating which is caused by the developer unit coupling breaking. The error code will vary according to the color of the affected developer unit.

Subcode

• 0100 = Yellow Developing Assembly.
• 0200 = Magenta Developing Assembly
• 0300 = Cyan Developing Assembly.
• 0400 = Black Developing Assembly.

How to fix the error:

Remove the developing unit to visually inspect the coupling which is located to the rear of the developer unit. I think it usually is the coupling, you can check the end of the Developers to make sure that the drive coupler wasn't broken.

Some of the possible causes:

• Check Developing drive assembly.
• Check the damage of the Developing Coupling.
• Remove the Hopper Unit and manually turn the Supply Input Gear to check rotation.
• Replace the Main Drive Unit.
•  Replace the Drum Driver PCB (UN4).

I hope this was helpful, don’t forget to share it via any of the share buttons on this page are highly welcomed as well.