canon imageclass mf4350d system error e225 solution. The error code e225 is for the Contact Image Sensor (CIS) lamp has a fault. You can see when the power is on. CIS comes in white, red, green and blue. If that doesn't happen, replace your CIS unit.
Canon imageclass mf4350d error code e225
canon imageclass mf4350d system error e225 solution |
Are you getting a system error on the CANON IMAGECLASS MF4320D error code E225 continues to display every time you turn on?
We are sharing a few methods to fix the Canon imageclass mf4320d, mf4350d the error e225, so check them one by one until it gets solved.
The maintenance sign means that the copier needs to be well serviced and checked if something is to be replaced. Consumables such as Toner, Drum, Blade, Fuser rollers, Pickup roller, and Developer are changed at such times. And also check the changing consumables are original or not. Always use spares having good quality. If you are sure that you have replaced the correct part or nothing is to be replaced, after ensuring these things, you can proceed to clear the sign. Always call experienced technicians for service.
Meaning of e225 error code:
The
error code e225 is for the Contact Image Sensor (CIS) lamp has a fault. You can
see when the power is on. CIS comes in white, red, green and blue. If that
doesn't happen, replace your CIS unit.
Fix e225 error code:
I
think the error code is the problem of the CIS lamp or home position sensor.
Open the copy glass, slide the scanner to the right side, and there is a black sensor in the back corner of the left side that appears to be the 'F' shape,
and the sensor is cleaned with a soft brush.
Some possible causes:
- Check the Contact Image Sensor (CIS) lamp.
- Clean the home position sensor.
- Check the scanner cable.
I
hope this was helpful, don’t forget to share it via any of the share buttons on
this page is highly welcomed as well.
It is showing error even the CIS has been replaced
ReplyDeleteHi, Wonderfully explained about the error code and its solutions. E225 error is mostly related to the sensor hardware. You should remove it, clean it and then fix it. If it works then its ok otherwise you would have to change the sensor lamp. We are toner suppliers in chennai and we also deal in spares related to printers and posts like these are very helpful to us and our service persons.
ReplyDelete